HP Designjet T1100

HP Designjet T Series — Service Manual 6-214
Removal and Installation - Left Spittoon
Left Spittoon
Removal
This procedure describes how to remove the complete Left Spittoon which is necessary to gain
access to other components.
Switch off the printer and remove the power cable.
1. Remove the Left Cover on page 6-30.
2. Remove the Electronics Module Main PCA
and P
SU. See page
6-202or 6-205
depending on the printer model.
3. Remove two T-8 screws that secure the Left
Spittoon to the printer.
4. Remove one T-10 screw that secures the
Left Spittoon to the printer.