HP Designjet T1100

HP Designjet T Series — Service Manual 6-223
Removal and Installation - Media Advance Roller (T1100/T1100ps/T610 ONLY)
Media Advance Roller (T1100/T1100ps/T610 ONLY)
Removal
1. Remove the Left Cover on page 6-30.
2. Remove the
Clean Out Assembly on page
6-90.
3. Remove the Electronics Module Main PCA
and P
SU. See page
6-202or 6-205
depending on the printer model.
4. Remove the
Left Spittoon on page 6-214.
5. Remove the
Media Advance Drive on page
6-218.
6. Remove the Media Advance Roller drive
gear wheel to gain access the locking
plate attachment screw.
The Media Advance Roller
drive gear is is delicate, and
should be removed straight off
the spindle.
7. Remove two T-15 screws that secure the
Media Advance Roller locking plate to the
printer.
Switch off the printer and remove the power cable.