HP Designjet T Series — Service Manual 6-245
Removal and Installation - Starwheel Motor
Starwheel Motor
Removal
1. Remove the Front Cover on page 6-16.
2. Re
move the Left Cover on page 6-30.
3. R
emove the Electronics Module Main PCA
and PSU. See page
6-202or 6-205
depending on the printer model.
4. Re
move the Left Spittoon on page 6-214.
5. Disconnect the Starwheel Motor electrical
connector.
6. Carefully pull the two gear wheels off their
shafts to gain access to the Starwheel
Motor attachment screws.
Switch off the printer and remove the power cable.
To Next Page
Loading...