Front panel procedure with paper on the roll
If there is paper on the roll, you can unload it from the front panel.
1.
Press
, then the roll icon, then Unload.
Alternatively, press
, then , then Paper > Paper unload > Unload roll 1 or
Unload roll 2.
2. You may need to open the roll cover.
Roll out of paper procedure
If the end of the paper is no longer attached to the core, use the following procedure.
1. If you have already started the unload process, press
on the front panel to cancel that
procedure.
2. Lift the blue lever on the left. If the front panel displays a warning about the lever, ignore it.
3. Pull out the paper from the printer. Pull from wherever the paper is accessible; the back of the
printer is recommended. You may need to open the roll cover.
4. Lower the blue lever.
Load a single sheet
1. When using a T1300 series printer, ensure that the cover of roll 1 is closed. If it is opened while a
sheet is loaded, the sheet will be immediately unloaded.
2.
At the front panel, press
then the roll 1 icon, then Load > Load sheet.
Alternatively, press
, then , then Paper > Paper load > Load sheet.
3. If a roll is already loaded, you have to wait while it is automatically unloaded. In the T1300 series
only, the roll is not unloaded, but withdrawn to the standby position, so that it can be printed on
again without reloading as soon as the sheet paper has been unloaded.
NOTE: If at any time you open a roll cover while that roll is in the standby position, the roll will
be automatically unloaded, and you will have to reload it the next time you want to print on it
(T1300 series only).
4. Select your paper category and type.
TIP: If you have loaded a paper type whose name does not appear in the paper list, see The
paper type is not in the driver on page 143.
ENWW
Load a single sheet
41
Paper handling
To Next Page
Loading...
