Need help?Do you have a question about the HP StorageWorks SN6000 - Fibre Channel Switch and is the answer not in the manual?
Defines the target readers for this user guide.
Lists the necessary knowledge and system requirements before installation.
Provides a list of additional HP documents for hardware and software.
Explains the formatting conventions and symbols used in the guide.
Details how to get technical assistance and access HP resources like websites.
Briefly outlines the content and structure of the user guide.
Specifies the minimum hardware and software needed to run the application.
Step-by-step guide for the initial setup of the management software.
Explains specific configuration steps for HP-UX servers and Emulex HBAs.
Procedures for upgrading an existing installation of the management software.
Instructions for uninstalling the management software from Windows and Linux systems.
Introduces the application window, menu bar, and navigation/content panes.
Details how to access and navigate the integrated help system for assistance.
Guides users through launching the application and performing initial setup.
Explains the feature enabling limited access between local and remote SAN fabrics.
How to view detailed information about switch and network configurations.
Procedures for viewing current switch zoning configurations and members.
Covers setting default zoning, admin password, IP address, firmware, SNMP, and DNS.
Details on creating, editing, deleting, and copying IPsec associations and policies.
How to access and view detailed information for HBAs within the SAN.
Procedures for updating HBA firmware (BIOS) and device drivers.
Guides on creating user-friendly names for HBAs and manually entering FDMI data.
How to view details of logical disks (LUNs) present in the SAN.
Step-by-step instructions for creating logical disks on EVA and MSA storage arrays.
Procedures for granting or revoking server access to logical disks (LUN masking).
Guides on increasing LUN size, removing LUNs, and creating aliases for them.
How to view details about servers, their HBAs, drives, and volumes.
Process to update the SAN's server inventory and topology view.
How to set or change the password for the server agent used for updates.
Detailed steps for creating, managing, and formatting disk partitions on servers.
How to access and view general information about storage subsystems.
Procedures for managing controllers and drives within a storage subsystem.
Steps to refresh the subsystem list and update storage subsystem firmware.
Guides on configuring subsystems using templates or custom deployments.
Addresses common problems like discovery, performance, OS support, and configuration errors.
To Next Page
General