HP StorageWorks Simple SAN Connection Manager User Guide 29
The program removal progress window opens and monitors the product removal. A progress bar shows
the percent of the uninstallation completed and icons show the status of each component as it is
removed, for example:
• A icon next to the component name indicates successful removal.
• A icon next to the component indicates that it has not yet been removed.
• A icon indicates that an error occurred during removal of this component.
When program removal is complete, you must reboot the computer.
4. Remove the Simple SAN Connection Manager CD from the CD-ROM drive.
5. Ensure that all running programs are closed, and then click Reboot to restart the computer.
Removing Simple SAN Connection Manager in Linux
Follow these steps to remove the Simple SAN Connection ManagerSimple SAN Connection Manager
software on a server running Linux.
CAUTION: If the system is booted from your SAN using the QLogic FC HBA driver, use the Linux
uninstallation option cautiously. Your QLogic FC HBA drivers will also be removed from the system, thus
making it un-bootable because the drivers are removed from the Linux initial RAM disk (initrd), the
temporary file system used by the Linux kernel during boot.
To remove the components required by Simple SAN Connection Manager on Linux:
1. Insert the installation CD into the CD-ROM drive of the server. The installation CD should mount
automatically in one of the following locations:
/media/cdrom/
/mnt/cdrom/
/media/cdrecorder/
If the installation CD is not mounted automatically, then issue the following commands to mount the CD:
# mkdir -p /mnt/cdrom
# mount /dev/cdrom /mnt/cdrom
2. Change directory to the linux directory. For example, if the installation CD is mounted in
/mnt/cdrom, issue the following command:
# cd /mnt/cdrom/HP_SSCM/linux/
3. Run the install_smb.sh script with the uninstall option as follows:
# ./install_smb.sh --uninstall
This will remove the following components:
• QLogic FC HBA Driver
• HP Array Configuration Utility, if installed
• QLogic SANsurfer agent, QLRemote, if installed
To Next Page
Loading...
Need help?
General