HP StorageWorks Simple SAN Connection Manager User Guide 43
Figure 20 Perform Other Operations dialog box
15. If you clicked Perform Other Operations on the Welcome... Configure Your SAN dialog box, select
from these common SAN configuration operations:
Logical Disk and Partition Operations:
•Click Assign Logical Disk to Server to open the Logical Disk Server Presentation dialog box (see
“Assigning and unassigning a logical disk to a server” on page 97).
•Click Create & Manage Partitions to open the Create & Manage Partitions dialog box (see
“Creating and managing partitions” on page 107).
•Click Expand Logical Disk Size to open the Expand Logical Disk dialog box (see “Expanding a
logical disk” on page 99).
•Click Delete Logical Disk to open the Delete Logical Disk dialog box (see “Deleting a logical
disk” on page 100).
Drive Operations:
•Click Manage Hot Spare Drive to set or remove a drive as a hot spare from the Manage Storage
Subsystem dialog box (see “Managing storage subsystems” on page 118).
•Click Blink Drive LED to flash a drive’s LED from the Manage Storage Subsystem dialog box (see
“Managing storage subsystems” on page 118).
Switch Operations:
•Click Set Switch IP Address to open the Set Switch IP Address dialog box (see “Setting the switch
IP address” on page 57).
•Click Update Switch Firmware to open the Switch Firmware Update wizard (see “Updating
switch firmware” on page 59).
HBA Operations:
•Click Update HBA BIOS to open the Update HBA BIOS wizard (see “Updating an HBA BIOS
image” on page 78).