24 Installing, upgrading, and removing Simple SAN Connection Manager
2. Click Upgrade.
A message box prompts you to confirm that you want to upgrade an existing version of Simple SAN
Connection Manager.
3. To continue with the upgrade, click Yes.
The end user license agreement is displayed.
4. Read the text of the HP end user license agreement, and then either click Agree to start the software
upgrade or Disagree to cancel the upgrade.
The installation upgrade checking components window opens while the wizard looks for components
that cannot be upgraded.
The installation progress window appears briefly, and then the Available Storage Subsystem dialog box
(Figure 6) prompts you to select the type of HP storage subsystem for this station.
Figure 6 Installation upgrade wizard: Available Storage Subsystem
5. Select one or more storage subsystems types (EVA and/or MSA) that exist in your SAN by choosing Yes
from the drop-down menu for the appropriate subsystem types. Then click OK to close this dialog box
and continue the upgrade.
The upgrade progress window appears. The progress window monitors the installation upgrade. A
progress bar shows the percent of the upgrade completed and icons show the status of each
component as it is upgraded, for example:
• A icon indicates a component previously installed for Simple SAN Connection Manager.
• A icon indicates a previously installed component that has now been successfully upgraded.
• A icon indicates either that the component was not previously installed but will be installed with
the upgrade, or that a previously installed component was removed manually using the Windows
Add/Remove Programs utility.
• A icon indicates that an error occurred during upgrade of this component. (The final wizard
window will provide additional information about component installation upgrade errors.)
After the FC driver is installed, a diagnostic window shows the HBA properties and targets found.
6. Click OK to close the SAN diagnostics window and continue.
If you are upgrading the Simple SAN Connection Manager software component on a system with EVA
storage, the Add EVA Management Account dialog box (Figure 7) prompts you to either select an
existing user account or to create a user account to manage your EVA.
To Next Page
Loading...
Need help?
General