NOTE: If you change the settings in this way, the changed settings apply to the current job but
are not saved permanently. You can change the default settings by pressing
, then , then
Print from USB preferences.
5.
To display a preview of the printed job on the front panel, press
.
When the preview is displayed, you can press it to zoom in on it. Press it again to zoom out.
6. When you are satisfied with the print settings, press Start.
7. If two rolls are loaded, you can choose to print on either roll, or you can let the printer choose
automatically.
NOTE: The printer will automatically rotate the image by 90° if it can save paper by doing so.
8. After printing, you can choose to print another file or go to the job queue. If you print another file
immediately without returning to the home screen, the temporary settings used for the previous file
are used again.
Print from a computer using HP Direct Print
1.
At the front panel, go to the home screen and press
.
2. Connect the computer to the Hi-Speed USB device port at the rear of the printer.
3. The front panel asks whether you want to print from an application, or using HP Direct Print.
NOTE: If you always select the same response, you can avoid this question before starting this
procedure by pressing
, then , then Setup > Direct printing preferences > Direct
print.
4. If you select HP Direct Print, the printer appears on your computer as an extra disk drive. (To print
from an application, see
Print from a computer using a printer driver on page 54.)
ENWW
Print from a computer using HP Direct Print
51
Printing
To Next Page
Loading...
