HP Deskjet 450 series - Page 61

58
reset device access
In order to change the printer’s wireless settings you must connect the printer to your
computer with a USB cable. Follow these steps to clear all bonded devices from the
printer’s memory:
1. Open the Toolbox, then open the Configure Bluetooth Settings dialog box.
2. Click the
Reset Device Access button.
A warning dialog box appears.
3. Click
OK to close the warning dialog box.
All bonded devices are removed from the printer’s memory.
reset to factory defaults
Follow these steps to reset the printer to the factory default settings:
1. Press and hold down the
Power ( ) button.
2. While holding down the
Power ( ) button, tap the Cancel ( ) button 4 times,
then tap the
Resume ( ) button 6 times.
3. Release the
Power ( ) button.