out of paper
if the paper tray is loaded
1. Adjust the length guide so that the paper stack touches the back of the paper
tray.
2. Slide the paper forward until it stops.
3. Press the Resume button.
if the paper tray is empty
1. Load paper in the tray.
2. Press the Resume button.
printer ejects the paper
● Move the printer away from direct sunlight. The printer may have been placed
in direct sunlight which can affect the Automatic Paper-Type Sensor.
—or—
● Select a paper type other than Automatic.
USB problems
there are conflicting USB cable connections
A printing conflict may arise when the printer and several USB devices are attached to a
hub. There are two methods for solving the conflict:
● Attach the printer's USB cable directly to the computer.
—or—
● If the printer is attached to a hub, do not use other USB devices attached to
the hub while printing.
printer does not turn on
The printer may have drawn too much power.
1. Disconnect the power cord from the printer.
2. Wait approximately 10 seconds.
3. Reconnect the power cord to the printer.
4. Press the Power button to turn on the printer.
file:///C|/Projects/Newport/Mac_UG_huykuna/ug_notprinting_fs.html (4 of 5) [5/9/2002 9:41:18 AM]
To Next Page
Loading...
