Wireless indicator light
The wireless indicator on the product flashes in special sequences to inform you about
various status or error conditions. Refer to the following table for information on solving
your error condition based on the wireless indicator flashing on the product.
Table 9-1 Wireless indicator light
Wireless button
light
Wireless
Description Solution
On The product is
connected to a
wireless network.
Wireless Protected
Setup (WPS)
successful.
The product can now print
wirelessly.
Blinking The product cannot
connect to a wireless
network.
No wireless signal
available but wireless
radio on the product is
turned on.
1. Check if the wireless
router or access point
is turned on.
2. Move the product
closer to the wireless
router or access point.
Blinking The product is
searching for
available wireless
networks.
Wireless Protected
Setup (WPS) in
progress.
Wait for product to connect
to an access point.
Fast blinking Wireless Protected
Setup (WPS)
progress error.
Press any key to clear the
error or wait for one minute.
Printing in ink-backup mode
Solution: If you receive the ink-backup mode message and two print cartridges are
installed in the product, verify that the protective piece of plastic tape has been
Chapter 9
60 Solve a problem
Solve a problem
To Next Page
Loading...