18. Remove the hinges (4).
19. If it is necessary to replace the wireless antenna assembly, remove the two Phillips PM2.5×4.0
screws (1) that secure the transceivers to the display enclosure.
20. Detach the wireless antenna transceivers (2) from the display enclosure.
21. Remove the wireless antenna cables from the clips (3) built into the display enclosure.
22. Remove the wireless antenna transceivers and cables (4) from the display enclosure.
Reverse this procedure to reassemble and install the Flush Glass display assembly.
94 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
Need help?
General