NOTE: The red WWAN antenna cable is connected to the WWAN module “Main” terminal. The
blue WWAN antenna cable is connected to the WWAN module “Aux” terminal.
5. Remove the two Phillips PM2.0×4.0 screws that secure the module to the computer (2).
6. Remove the WWAN module (3) by pulling the module away from the slot at an angle.
NOTE: WWAN modules are designed with a notch (4) to prevent incorrect insertion.
Reverse this procedure to install the WWAN module.
66 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
Need help?
General