Heading Option Description
IDE Channel 0 Master This allows you to detect the device.
IDE Channel 1 Master Also it allows you to set the IDE deviceto:
• None
• Auto(default)
• Manual
Access Mode This allows you to set the access mode to:
• CHS
• LBA
• Large
• Auto(Default)
Also,this allows you to see the Hard disk
information. (view only):
• Capacity
• Cylinder
• Head
• Precomp
• Landing Zone
• Sector
Halt On Allows you to set at:
• All errors
• No errors
• All,but Keyboard
SATA Controller This allows you to set for:
• Disabled
• Enabled (default)
LEGACY Mode support This allows you to set for:
• Enabled (default)
• Disabled
Computer Setup (F10) Utility Guide www.hp.com/in 7-5
Computer Setup (F10) Utility
Computer Setup (Continued)
!
Support for specific Computer Setup options may vary depending on the hardware configuration
To Next Page
Loading...
