Recovery Either correct the coding error, use linker (Binder or nld utility) to add the procedure to
the code area or user library, or refer the call to a procedure that is already present in the
application program.
2 (%001000) NO PCB AVAILABLE
Cause All entries in the configured process control block (PCB) table for the processor were in use
or the process required a low PIN but none were available.
Effect No process is created.
Recovery Try a different processor or wait and then retry the existing call.
3 (%001400 + %nnn) FILE-SYSTEM ERROR ON program-file
Cause The system monitor encountered a file-system error while accessing program-file during
process creation.
Effect The call returns the error number of the file-system error (%nnn) in error.<8:15>. No process
is created.
Recovery Refer to “File-System Errors” (page 19) for corrective action for error number %nnn.
4 (%002000) UNABLE TO ALLOCATE MAP
Cause Not enough space was available in the processor's MAPPOOL to permit the system monitor
to generate the code and data-map copies required by the new process (a configuration problem).
Effect No process is created.
Recovery Try a different processor or wait and then retry the existing call.
5 (%002400 + %nnn) FILE-SYSTEM ERROR ON SWAP FILE
Cause An error occurred during the creation or opening of the swap file.
Effect File-system error %nnn is returned in error.<8:15>. No process is created.
Recovery Refer to “File-System Errors” (page 19) for corrective action for error number %nnn.
6 (%003000 + %nnn) ILLEGAL FILE FORMAT
Cause When the system monitor checked on whether this file is a program, the program or library
file failed the test. (The system monitor includes checks for file codes 100 and 700.)
Bits <8:15> (%nnn) contain an error subcode that indicates the invalid file format. Bit 15 is set to
0 if a program file is in error and to 1 if a library file is in error. Error subcodes are listed in Table 6.
Table 6 NEWPROCESS Error 6 Error Subcodes
MeaningOctalDecimal
The program file is not a disk file.%0022
The library file is not a disk file.%0033
The program file does not have file code 100 or 700.%0044
The library file does not have file code 100 or 700.%0055
The program file does not have the correct file structure.%0066
142 NEWPROCESS AND NEWPROCESSNOWAIT Errors
To Next Page
Loading...
