HP Guardian Errors - Error Lists; 22: Zgrd-Val-Process-Create

Recovery Take corrective action as indicated by the subcode. In many cases, the object file was
built improperly or corrupted; it should be relinked and perhaps recompiled.
5xx FILE-SYSTEM ERROR ON SHARED RUN-TIME LIBRARY (SRL)
NUMBER XX
Cause There was a file-system error on shared run-time library (SRL) number xx; error-detail
information contains a file-system error number.
Effect No process is created.
Recovery Refer to “File-System Errors” (page 19), for corrective action for the file-system error
returned in the error-detail information. If the problem persists, contact your service provider.
1100-1499 INTERNAL ERROR WITHIN A MODULE OF THE OPERATING SYSTEM
Cause An internal error was detected within a module of the operating system.
Effect No process is created.
Recovery Report the internal error and any error detail that accompanied it to your service provider.
Error Lists
If you are using the Subsystem Programmatic Interface (SPI) to send commands to a subsystem,
you might receive an error list in a response. HP subsystems return such an error list when, in
performing your request, they call the PROCESS_LAUNCH_ or PROCESS_CREATE_ procedure
directly or indirectly and an error occurs on the call.
The standard SPI token ZSPI-TKN-PROC-ERR, which is present in every PROCESS_LAUNCH_ and
PROCESS_CREATE_ error list, identifies the procedure that was called. Its value is
ZGRD-VAL-PROCESS-CREATE (22) for PROCESS_CREATE_ and ZGRD-VAL-PROCESS-LAUNCH
(25) for PROCESS_LAUNCH_.
Each error list always includes the unconditional tokens listed under its description in this subsection.
In addition, each error list can include any of the conditional tokens listed under its description.
If you are designing a subsystem that uses SPI, follow these guidelines when constructing a
PROCESS_LAUNCH_ or PROCESS_CREATE_ error list:
• Include all unconditional tokens listed in the error-list description.
• Optionally include any or none of the conditional tokens listed in the error-list description.
This subsection does not discuss the mechanics of error-list construction. For information about
creating error lists, additional information about tokens and token types, and definitions of tokens
whose names begin with ZSPI-, refer to the SPI Programming Manual.
22: ZGRD-VAL-PROCESS-CREATE
A call to PROCESS_CREATE_ failed due to an error.
Unconditional Tokens
ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST.
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR.
ZSPI-TKN-PROC-ERR token-type ZSPI-TYP-ENUM.
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL.
Conditional Tokens
ZGRD-TKN-XOBJECTFILE token-type ZSPI-TYP-STRING.
ZGRD-TKN-XLIBRARYFILE token-type ZSPI-TYP-STRING.
ZGRD-TKN-XSWAPFILE token-type ZSPI-TYP-STRING.
ZGRD-TKN-EXTSWAPFILE token-type ZSPI-TYP-STRING.
ZGRD-TKN-PRIORITY token-type ZSPI-TYP-UINT.
ZGRD-TKN-XCPU token-type ZSPI-TYP-UINT.
ZGRD-TKN-PROCESSHANDLE token-type ZSPI-TYP-PHANDLE.
ZGRD-TKN-ERRORDETAIL token-type ZSPI-TYP-INT.
ZGRD-TKN-NAMEOPTION token-type ZSPI-TYP-ENUM.
ZGRD-TKN-XPROCESSNAME token-type ZSPI-TYP-STRING.
182 Process Creation Errors