Cause An error occurred during an attempt to obtain or propagate security identity information.
The error-detail information contains the number of the file-system error that occurred.
Effect No process is created.
Recovery Refer to “File-System Errors” (page 19), for corrective action for the file-system error
returned in the error-detail information. If the file-system error indicates an invalid operation or an
invalid parameter, the problem might be caused by a version mismatch between the NonStop
operating system and Standard Security. Correct your system configuration if this is the case.
Otherwise, the problem is likely to be an internal error that should be reported to your service
provider.
35 INTERNAL PROCESS CREATION ERROR
Cause An internal error occurred in the PROCESS_LAUNCH_, PROCESS_CREATE_, or
PROCESS_SPAWN_ procedure.
Effect No process is created.
Recovery Make a note of the error subcode returned in the error-detail information and retry the
call. Contact your service provider.
36 CHILD'S PFS ERROR
Cause An error occurred in the specification of the process file segment (PFS). The error-detail
information contains the error number of the file-system error that occurred.
Effect No process is created.
Recovery Refer to “File-System Errors” (page 19), for corrective action for the file-system error
returned in the error-detail information. For example, if file-system error 31, "Unable to obtain
file-system buffer space," is returned, specify a larger PFS size for the process.
37 UNABLE TO ALLOCATE GLOBAL DATA FOR THE PROCESS
Cause Process memory-segment limit exceeded.The system was unable to allocate the global data
segment of a native process. If non-zero, error-detail indicates:
1. Insufficient swap space available from KMSF
2. Overlap of Vaddrs
3. Too many segments loaded
Effect No process is created. The name of the file for which the error occurred may have been
reported to the home terminal.
Recovery Contact your local service provider.
38 UNABLE TO LOCK IOP GLOBAL DATA FOR THE PROCESS
Cause The system was unable to lock the global data segments of a native I/O process. This error
is only returned to some privileged callers.
Effect No process is created.
Recovery Stop processes or wait until the system load decreases before attempting to run this
process.
40 THE MAIN STACK MAXIMUM VALUE, SPECIFIED EITHER BY THE
PROCEDURE CALL OR BY THE OBJECT FILE, IS TOO LARGE
Error Codes 167
To Next Page
Loading...
