HP iPAQ rx1900 - Page 88

88
Setting Up a Wireless Access Point (WAP)
Gateway
To access WAP sites through Internet Explorer Mobile, configure your
device to use a WAP gateway. Use the following steps to create a new
set of connections to the Internet with WAP gateway settings.
Before you begin, obtain the following information from your Internet
Service Provider (ISP), wireless service provider, or network administrator:
• user name
• password
• ISP server phone number
• WAP gateway server name
• port number
To set up a WAP gateway:
1. Tap Start > Settings > Connections tab > Connections.
2. Tap Edit my proxy server. If a proxy server has not been set
up, tap Set up my proxy server.
3. On the Proxy Settings tab, select the This network
connects to the Internet and This network uses a proxy
server to connect to the Internet check boxes.
4. If necessary, in the Proxy server box, enter the proxy server
name.
5. Tap Advanced > WAP.
6. In the Server box, enter the WAP gateway server name. Under
Port, enter the port number. The most common WAP port number
is 9201.
7. Enter any logon credentials required by the WAP gateway server.