HP JetDirect 300X - Installing DLC Transport and Driver Software

144 Printing on Windows NT DLC/LLC Networks
EN
Installing the DLC Transport and
Driver Software
All software necessary to support the HP JetDirect print server is
included with the Windows NT operating system. Follow the steps
below to install the DLC Transport and Driver software for the
HP JetDirect print server.
Note The HP Network Port software is installed
automatically with the DLC protocol.
Windows NT 4.0
1. Log onto the network with Supervisor privileges at any user
workstation.
2. Run
Windows NT
.
3. Right-click on
Network Neighborhood
and then click
Properties
. The
Network
window appears.
4. Click the
Protocols
tab and then click
Add
. The
Select Network
Protocol
box appears.
5. Select
DLC Protocol
and then click
OK.
6. Follow the directions on the screen to complete the installation.
7. To verify that the DLC software is installed, right-click on
Network Neighborhood
, click
Properties
, and then click the
Protocols
tab. Make sure that DLC Protocol appears in the
Network Protocols
window.