Need help?Do you have a question about the HP jetdirect 175x and is the answer not in the manual?
General| Network ready | Yes |
|---|---|
| Power supply type | AC/DC |
| Cabling technology | 10/100Base-T(X) |
| Networking features | Fast Ethernet |
| Compatible operating systems | Windows 98 Windows NT 4.0 Windows Me Windows 2000 Windows Server 2003 Windows XP (32/64-bit) Windows Vista (32/64-bit) Windows 2003 (64-bit) Mac OS 8.6+ |
| Product color | White |
| Firmware upgradeable | No |
| Number of simultaneous printers | 1 |
| Storage temperature (T-T) | -40 - 70 °C |
| Operating temperature (T-T) | 0 - 55 °C |
| Operating relative humidity (H-H) | 15 - 95 % |
| Safety | IEC |
| Certification | FCC, DoC |
| AC input voltage | 100-127 V |
| AC input frequency | 60 Hz |
| Power consumption (typical) | 2.8 W |
| Supported network protocols | TCP/IP, IPX/SPX, AppleTalk, IP Direct, LPD, Telnet, SLP, IGMP, BOOTP/DHCP, WINS, SNMP, HTTP, Auto-IP, Bonjour |
| Flash memory | 2 MB |
| Minimum storage drive space | 40 MB |
| Minimum system requirements | CD-ROM |
| Networking standards | IEEE 802.3, IEEE 802.3u |
| Ethernet LAN data rates | 10, 100 Mbit/s |
| Network connection type | Ethernet LAN |
| Copper ethernet cabling technology | 100BASE-T, 100BASE-TX, 10BASE-T |
| USB connector type | USB Type-A |
| USB 2.0 ports quantity | USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them. |
| Parallel ports quantity | 0 |
| Cables included | USB |
Weight and Dimensions| Depth | 127 mm |
|---|---|
| Width | 101.6 mm |
| Height | 38.1 mm |
| Weight | 118 g |
Lists supported HP Jetdirect print server models and firmware versions.
Details the network protocols supported by HP Jetdirect print servers.
Details the setup wizard for configuring wireless print servers.
Enterprise management tool for HP Jetdirect print servers and other network devices.
Utility for configuring wireless print servers on Mac OS networks.
Details how default IP addresses are assigned or not assigned.
Explains the use of BOOTP/TFTP for automatic TCP/IP configuration.
Describes how to use DHCP for automatic IP configuration.
Procedures to reset parameters to factory default values.
Lists and describes various error codes and messages.
Methods for configuring TCP/IP parameters like IP address, subnet mask.
Steps to set up a wireless connection for the print server.
To Next Page