ENWW HP Jetdirect 802.11b Wireless Print Servers 267
3. In the Confirm Wireless Settings screen, verify your settings.
If necessary, click TCP/IP Settings to set your IP address.
Some networks may require presetting TCP/IP parameters for
network access (for example, to accommodate special DHCP
requirements or Access List restrictions).
4. When your HP Jetdirect print server has been configured with
your wireless network settings, click Finish.
5. Verify that your printer can communicate on your network. See
To Verify the Wireless Network Connection
.
Be sure to reconfigure your wireless computer so that it can
regain access to your network. To install the printer on your
wireless computer, see Install the Printer on Your Network
Systems.
HP WPS Assistant (Mac OS X 10.1.5 or later). This utility
allows you to configure an HP Jetdirect wireless print server with
a connection to your Mac OS network.
To use this utility, the HP Jetdirect wireless print server must be
in a factory-default state. Proceed as follows:
1. Insert the CD-ROM into your Mac OS system.
2. Select and open the HPJETDIRECT CD-ROM icon.
3. If provided, read the release notes for updated information.
4. Select and open the HP WPS Assistant folder.
5. Run the HP WPS Assistant utility, then follow the instructions
on the screen.
Once a wireless connection has been created, you will need to use
other utilities (such as the HP LaserJet Utility for Mac OS) to
configure and manage your printer for printing.
Note Optionally, you may use the embedded Web server
to configure a network connection. See Chapter 4
.
To Next Page
Loading...
