HP jetdirect 175x User Manual

ENWW Using the Embedded Web Server 145
By factory default, a self-signed Jetdirect certificate is
preinstalled. For wireless print servers, this allows the embedded
Web server to use HTTPS and appear as a secure site when
initially accessed from your Web browser.
Click View to view the contents of an installed Jetdirect
certificate, or click Configure to update or install a new one. See
Configuring Certificates
.
When installed, a Jetdirect certificate will be saved across a
cold-reset, which is used to restore the print server to
factory-default values.
● CA Certificate. (Wireless print servers only) A certificate from
a trusted third party, or Certificate Authority (CA), is used to
validate the identity of a network authentication server during
selected authentication methods that use EAP (Extensible
Authentication Protocol). The authentication server’s identity is
validated when information on the CA certificate matches the
information on a certificate received from the authentication
server.
A CA certificate for the print server is a certificate that was used
to sign the authentication server’s certificate. Therefore, the
Certificate Authority for the authentication server’s certificate
must also be used for the CA certificate.
Click View to view the contents of an installed Jetdirect
certificate, or click Configure to update or install a new one. See
Configuring Certificates
.
A CA certificate is not saved when the print server is reset to
factory-default values.
The maximum certificate size that can be installed on the HP
Jetdirect print server is 3072 bytes.
Configuring Certificates
When you click Configure, a certificate management wizard will
help you update or install a certificate. The screens displayed will
depend on the type of certificate (Jetdirect or CA) and your
selections. Table 4.12
provides a description of the screens and
configuration parameters that may appear.

HP jetdirect 175x Specifications

General

Network ready	Yes
Power supply type	AC/DC
Cabling technology	10/100Base-T(X)
Networking features	Fast Ethernet
Compatible operating systems	Windows 98 Windows NT 4.0 Windows Me Windows 2000 Windows Server 2003 Windows XP (32/64-bit) Windows Vista (32/64-bit) Windows 2003 (64-bit) Mac OS 8.6+
Product color	White
Firmware upgradeable	No
Number of simultaneous printers	1
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 55 °C
Operating relative humidity (H-H)	15 - 95 %
Safety	IEC
Certification	FCC, DoC
AC input voltage	100-127 V
AC input frequency	60 Hz
Power consumption (typical)	2.8 W
Supported network protocols	TCP/IP, IPX/SPX, AppleTalk, IP Direct, LPD, Telnet, SLP, IGMP, BOOTP/DHCP, WINS, SNMP, HTTP, Auto-IP, Bonjour
Flash memory	2 MB
Minimum storage drive space	40 MB
Minimum system requirements	CD-ROM
Networking standards	IEEE 802.3, IEEE 802.3u
Ethernet LAN data rates	10, 100 Mbit/s
Network connection type	Ethernet LAN
Copper ethernet cabling technology	100BASE-T, 100BASE-TX, 10BASE-T
USB connector type	USB Type-A
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Parallel ports quantity	0
Cables included	USB

Weight and Dimensions

Depth	127 mm
Width	101.6 mm
Height	38.1 mm
Weight	118 g