EN
23
3
TCP/IP Configuration
Introduction
To operate properly on a TCP/IP network, the HP JetDirect print
server must be configured with valid TCP/IP network configuration
parameters, such as an IP address. Depending on your printer and
system, this can be done in the following ways:
Note When shipped from the factory, the HP JetDirect
print server has no IP address. If the HP JetDirect
print server is not configured with a valid IP
address within two minutes after power up, a
factory default value of 192.0.0.192 will be
automatically assigned. This address must be
reconfigured with a valid address for use on your
TCP/IP network. For more information on TCP/IP
networks, see appendix A.
●
By downloading the data from a network-based UNIX server
using BOOTP (Bootstrap Protocol) and TFTP (Trivial File
Transfer Protocol) each time the printer is turned on.
Note The BOOTP daemon, bootpd, must be running on a
BOOTP server that is accessible by the printer.
To Next Page
Loading...
