42 TCP/IP Configuration
EN
7. Edit the
/etc/ethers
file (
/etc/rarpd.conf
file in HP-UX
10.20) to add the LAN hardware address/station address (from
the configuration page) and the node name for the HP JetDirect
print server. For example:
00:60:b0:a8:b0:00 laserjet1
Note If your system uses Network Information Service
(NIS), you need to incorporate changes to the NIS
host and ethers databases.
8. Turn the printer on.
9. To verify that the card is configured with the correct IP address,
use the ping utility. At the prompt, type:
ping <IP address>
where
<IP address>
is the assigned address from RARP. The
default IP address is 192.0.0.192.
10. If ping does not respond, see the chapter “Troubleshooting the
HP JetDirect Print Server.”
To Next Page
Loading...
