106 FTP Printing EN
FTP Login
To start an FTP session, enter the following command from a
MS-DOS or UNIX command prompt:
ftp <IP address>
where <IP address> is the valid IP address or node name
configured for the HP Jetdirect print server. See Figure 5.1
Figure 5.1 FTP Login Example
If the connection is successful, a Ready message will be displayed.
After a successful connection, the user is prompted for a login name
and password. The default is the client’s login name. The Jetdirect
FTP server will allow any user name. Passwords are ignored.
If login is successful, a message “230” will be displayed on the client
system. In addition, the available HP Jetdirect ports for printing
will be displayed. HP Jetdirect internal print server cards provide
a single port (Port 1). HP Jetdirect external print servers with
multiple ports will display all available ports, with Port1 the default
port. To change ports, use the FTP cd (change directory) command.
For a typical FTP printing session, see “Example of an FTP Session
.”
To Next Page
Loading...
