EN TCP/IP Configuration 41
T145 -- Idle Timeout option. An HP-proprietary tag to set the idle
timeout (seconds), which is the amount of time that a print
data connection may remain idle before being closed. The
range is 1 - 3600 seconds.
T146 -- Buffer Packing option. An HP-proprietary tag to set buffer
packing for TCP/IP packets.
0 (default): Normal, data buffers are packed before
sending to the printer.
1: Disable buffer packing. Data is sent to the printer
when received.
T147 -- Write Mode option. An HP-proprietary tag that controls the
TCP PSH flag setting for device-to-client data transfers.
0 (default): disables this option, flag not set.
1: all-push option. The push bit is set in all data packets.
2: eoi-push option. The push bit is set only for data packets
that have an End-of-Information flag set.
T148 -- IP Gateway Disable option. An HP-proprietary tag to
prevent configuration of a gateway IP address. 0 (default)
allows an IP address. 1 prevents a Gateway IP address to
be configured.
T149 -- Interlock Mode option. An HP-proprietary tag that specifies
whether an acknowledgement (ACK) on all TCP packets
is required before the printer is allowed to close a Port 9100
print connection. To accommodate multiport print servers,
a Port Number and Option value are specified. Port
Numbers can be 1 (default), 2, or 3. Option value 0
(default) disables interlock, 1 enables.
Example: 2 1 specifies Port 2, interlock enabled
T150 -- TFTP server’s IP address option. An HP-proprietary tag to
specify the TFTP server’s IP address where the TFTP
configuration file is located.
T151 -- Network Configuration option. An HP-proprietary tag to
specify either “BOOTP-ONLY” or “DHCP-ONLY” requests
be sent.
Table 3.1 Tags Supported in a BOOTP/DHCP Boot file (3 of 3)
Item RFC
2132
Option
Description
To Next Page
Loading...
