66 TCP/IP Configuration EN
Using Telnet
This section describes how to configure the print server (firmware
version x.21.01 or greater) using Telnet.
Note To use Telnet commands with the HP Jetdirect
print server, a route must be available from your
workstation to the print server. This means that
there must be a match between the network
identification of your system to that of the
HP Jetdirect print server. (For example, if the
print server is configured with it’s default IP
address, a route may not exist.)
On Windows 95/98 and NT/2000 systems, you can
use the following route command at a DOS prompt
to add a route to the print server:
where <Jetdirect IP address> is the IP address
configured on the HP Jetdirect print server, and
<system IP address> is the IP address of the
workstation's network card that is attached to the
same physical LAN as the print server.
Example:
route add <Jetdirect IP Address> <system IP Address>
route add 192.168.45.39 192.170.1.2
To Next Page
Loading...
