To use the auto-adjustment feature:
1.
Allow the monitor to warm up for 20 minutes before adjusting.
2.
Press the Auto Adjust button on the monitor front panel.
●
You can also press the Menu button, then select Auto-Adjustment from the OSD Basic Main
Menu or Image Control > Auto-Adjustment from the OSD Advanced Main Menu. Refer
to Adjusting the Monitor Settings on page 20 in this chapter.
●
If the result is not satisfactory, continue with the procedure.
3.
Insert the CD in the disc drive. The CD menu is displayed.
4.
Select Open Auto-Adjustment Software. The setup test pattern is displayed.
5.
Press the Auto Adjust button on the monitor front panel to produce a stable, centered image.
6.
Press the ESC key or any other key on the keyboard to exit the test pattern.
18 Chapter 4 Operating the Monitor
ENWW
To Next Page
Loading...
Need help?
General
