HP Laser Jet 5550 - Page 118

Setting the idle timeout
1. Press (HP Color LaserJet 5500 models) or M ENU (HP Color LaserJet 5550 models) to
enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight I/O.
5. Press
to select I/O.
6. Press
to highlight EIO X (where X = 1, 2, or 3).
7. Press
to select EIO X.
8. Press
to highlight TCP/IP.
9. Press
to highlight MANUAL SETTINGS.
10. Press
to select MANUAL SETTINGS.
11. Press
to highlight IDLE TIMEOUT.
12. Press
to select IDLE TIMEOUT.
13. Press the
or arrow to to increase or decrease the number of seconds for the idle
timeout.
14. Press
to save the idle timeout.
15. Press the P
AUSE /R ESUME (HP Color LaserJet 5500 models) or M ENU (HP Color LaserJet
5550 models) button to return to the Ready state.
Setting the link speed
By factory default, the link speed is set to AUTO. Use the following procedure to set a
specific speed:
1. Press
(HP Color LaserJet 5500 models) or M ENU (HP Color LaserJet 5550 models) to
enter the MENUS.
2. Press
to highlight CONFIGURE DEVICE.
3. Press
to select CONFIGURE DEVICE.
4. Press
to highlight I/O.
5. Press
to select I/O.
6. Press
to highlight EIO X (where X = 1, 2, or 3).
7. Press
to select EIO X.
8. Press
to highlight LINK SPEED.
9. Press
to select LINK SPEED.
10. Press
to highlight the desired link speed.
11. Press
to select the desired link speed.
12. Press the P
AUSE /R ESUME (HP Color LaserJet 5500 models) or M ENU (HP Color LaserJet
5550 models) button to return to the Ready state.
96 Chapter 3 Installation and configuration ENWW