6. Holding the DIMM by the edges, align the notches on the DIMM with the bars in the
DIMM slot.
Note
If you have difficulty inserting the DIMM or closing the latches, make sure the notches on the
bottom of the DIMM are aligned with the bars in the slot. If the DIMM still does not go in,
make sure you are using the correct type of DIMM.
7. Firmly press the DIMM straight into the slot. Close the locks on each side of the DIMM
until they snap into place.
8. Align the formatter board in the tracks at the top and bottom of the slot, and slide the
board back into the printer. Replace and tighten the eight screws removed in step 2.
9. Reconnect the power cable and interface cables, and turn the printer on.
118 Chapter 4 Printer Maintenance ENWW
To Next Page
Loading...