Causes for jams in the duplex path
Cause
Solution
Duplex feed rollers are worn or damaged. Replace the ETB unit. Calibrate the printer after
replacing the ETB. See
Calibrate now.
Duplex feed roller drive gears are worn or
damaged.
Replace the ETB unit. Calibrate the printer after
replacing the ETB. See
Calibrate now.
Duplex feed guides are damaged. Check the top cover and front cover guides, and
replace the covers if necessary.
Replace the ETB unit. Calibrate the printer after
replacing the ETB. See
Calibrate now.
Timing belts are defective. Replace the ETB unit. Calibrate the printer after
replacing the ETB. See
Calibrate now.
Table 7-13. Jams in the duplex path (continued)
340 Chapter 7 Troubleshooting ENWW
To Next Page
Loading...