22 Chapter 2 - Removal and replacement Q1342-90910
Output sensor
1 Remove the following assemblies:
z Toner cartridge, media tray, and cable pod. See “Toner cartridge”
on page 15 through “Cable pod” on page 17.
z Left side and back covers. See “Left side cover” on page 18
through “Back cover” on page 19.
2 Disconnect the output sensor (callout 1) wire harness (at the ECU
end). Unlace the harness from the harness lance points.
3 Remove the single output sensor mounting screw and remove
the sensor.
Figure 11. Remove the output sensor
11
To Next Page
Loading...