7. Remove 4 screws (callout 2, figure 5-20).
1
2
Figure 5-20. Removing the engine power assembly (1 of 2)
8. Remove 2 screws from the back of the printer (callout 1, figure 5-21).
Note
Be aware of the two springs behind the engine power assembly to avoid losing them.
1
Figure 5-21. Removing the engine power assembly (2 of 2)
Note
When reinstalling the engine power assembly, ensure that the cable guide is properly
installed, clipping it onto the PCB at the top back corner and onto the metal casing.
Fuser (fixing) assembly
1. Remove the right side cover.
2. Remove the left side cover.
3. Remove the print cartridge access door, fuser cover, and rear panel.
ENWW Internal assemblies 73
To Next Page
Loading...