Laser/scanner assembly
1 Remove the following assemblies.
● Right-side cover. See
Right-side cover on page 68.
● Left-side cover. See
Left-side cover on page 70.
● Top-cover assembly. See
Rear panel and top-cover assembly on page 70.
● Front-cover. See
Front cover on page 75.
● Engine control unit assembly. See
Engine control unit (ECU) assembly on page 85.
2 Remove four screws (callout 1) and then remove the laser/scanner assembly.
1
Figure 5-34 Removing the laser/scanner assembly
Reinstallation tip When replacing the laser/scanner assembly, be sure to transfer the laser
shutter arm from the old assembly to the new one.
ENWW Internal assemblies 89
To Next Page
Loading...