Removing the Tray 1 Pickup Assembly
1. Remove Tray 1 by opening the tray at a 45° angle and pulling
up on the tray (Figure 18).
2. Unplug the two cables (Callout 2 in Figure 19) by grasping the
cables where they attach to the plug and pulling straight back.
3. Route the cables through the right side of the printer chassis
and bring them to the front.
4. Remove the 5 screws (callout 1 in Figure 19) from the front of
the pickup assembly. (Two screws are adjacent in the lower left
corner.)
Figure 18 Removing Tray 1.
HP LaserJet 5P Printer Service Supplement
Removal and Replacement
44
To Next Page
Loading...