Removing the DC Controller Assemblies
The DC Controller Assembly is located on the bottom of the
printer. The PCA is protected by a metal shield assembly, and is
mounted to a plastic base. The Formatter PCA and Fusing
Assemblies are connected directly into the DC Controller and must
be removed prior to removal of the DC Controller Assembly.
Caution
Failure to remove these components before
removing the DC Controller will result in
printer damage.
1. Remove the printer covers (page 39), Formatter PCA and Shield
(page 48), and Fusing Assemblies (page 50).
2. On the right side, remove the machine screw and washer
(Figure 25) holding the grounding spring in place. (Callout 1 in
Figure 25).
3. Disconnect the two cables to the tray 1 assembly (callout 2 in
Figure 25).
HP LaserJet 5P Printer Service Supplement
Removal and Replacement
51
To Next Page
Loading...