3. Place the stack of envelopes into the tray with the flaps on the right side, the side to be printed
facing up, and with the short edge leading into the printer.
NOTE If the envelope has a flap on a short edge, this edge must enter the printer first.
4. Slide the side-width guides inward until they lightly touch the stack without bending it. The stack
should be centered between the guides and must be under the tabs on the guides.
5. Select the envelope you are using as the Size in the printer driver.
Printing on labels
Follow these guidelines for using labels. See Print-media specifications for more details.
CAUTION To avoid damaging the printer, use only labels that are recommended for laser
printers. Never print on the same sheet of labels more than once or print on a partial sheet of
labels.
●
Avoid labels that are separating from the backing sheet or are wrinkled or damaged in any way.
30 Chapter 3 Printing tasks ENWW
To Next Page
Loading...
