If you have more than one driver installed on your product, the Update Now feature works automatically
only on the driver on which it is activated. The other driver will not be updated, and might show the
default setting for your product model.
Tray 3
This control specifies whether you have tray 3, an additional 500-sheet tray, installed on your product.
The default setting is Not Installed.
Duplex Unit (for 2-Sided Printing)
The HP Color LaserJet 3600dn printer models comes with a duplex unit installed. This setting is enabled
(Installed) by default.
NOTE These printer models support smart duplexing. The product uses the smart duplexing
feature to detect information on both sides of the print job pages and only runs the pages through
the duplexing unit if there is printable information on the second side of the page.
Allow Manual Duplexing
Select Allow Manual Duplexing to print on both sides of any size and most types of media (except
transparencies, envelopes, and labels). To use this feature, you must reinsert the media stack into the
input tray to print the second side. The product pauses while you make this adjustment.
This setting is enabled by default.
Printer Memory
This option matches the setting to the amount of memory that is installed in the product. The driver
generates ranges of memory that can be selected, up to the maximum that the product can accept. The
driver can use this information to manage how the print driver uses the product memory.
ENWW Device Settings 153
HP JetReady 4.2 host-
based driver for Windows
To Next Page
Loading...