A blank check box indicates that the feature is not installed. A check mark appears when you select an
install state for that feature.
Information about the space required and the space available on your hard drive is shown on the dialog
box.
Any combination of features can be selected for the installer, and none depends on any other selection.
It is possible to create a custom installer that installs features without including a print driver. Select the
drivers you want to install (or select none of them if you do are not installing a driver).
Click Next to proceed with the installation. The Additional Software dialog box opens.
To view details about the drivers, click Details. The driver Details dialog box appears.
Figure 5-22 Driver Details dialog box
All the drivers that are available on the Drivers dialog box are described in the Details dialog box. Click
OK to return to the Drivers dialog box.
On the Drivers dialog box, click Next to continue the installation. The Additional Software dialog box
appears.
ENWW Installation instructions 177
Installation in Windows
To Next Page
Loading...