In the Confirm Network Settings dialog box, click Next to continue the installation. The Installation
Type dialog box opens (see
Figure 5-20 Installation Type dialog box).
If you click Change Settings…, the Confirm Change Setting dialog box opens, as shown in the
following figure.
WARNING! When you change the TCP/IP configuration by using the Change Settings button,
you change the actual settings in the product Jetdirect card. You should make changes to these
settings only with the advice of your network administrator.
Figure 5-14 Confirm Changing Setting dialog box
If you click No, the Installation Type dialog box opens (see
Figure 5-20 Installation Type dialog box).
If you click Yes, the Change TCP/IP Settings dialog box opens (see Figure 5-19 Change TCP/IP
Settings dialog box).
The Check Printer Connection dialog box, which appears if you selectedNo, I want to install a
different printer in the Printer Found dialog box or if the system failed to detect the product over the
network, is shown in the following figure.
284 Chapter 5 Installing Windows printing-system components ENWW
To Next Page
Loading...