Replace supplies and parts
Carefully follow the guidelines in this section when replacing printer supplies.
Supply replacement guidelines
To facilitate the replacement of supplies, keep the following guidelines in mind when setting up the
printer.
●
Sufficient space is required above and in the front of the printer for removing supplies.
●
The printer should be located on a flat, sturdy surface.
For instructions on installing supplies, see the installation guides provided with each supply item or see
more information at
http://www.hp.com/support/cljcp3505.
CAUTION: Hewlett-Packard recommends the use of HP products in this printer. Use of non-
HP products may cause problems requiring service that is not covered by the HP warranty or
service agreements.
Change print cartridges
When a print cartridge approaches the end of useful life, the control panel displays a message
recommending that you order a replacement. The printer can continue to print using the current print
cartridge until the control panel displays a message instructing you to replace the cartridge.
The printer uses four colors and has a different print cartridge for each color: black (K), cyan (C), magenta
(M), and yellow (Y).
Replace a print cartridge when the printer control panel displays a REPLACE <COLOR>
CARTRIDGE message.
NOTE: If all of the print cartridges wear out at the same time and you are printing mostly
monochrome (black and white), you should change the print mode to MOSTLY BLACK
PAGES. See
System Setup sub-menu on page 20 for more information.
ENWW Replace supplies and parts 125
To Next Page
Loading...
