Control panel message Description Recommended action
REPLACE <COLOR> CARTRIDGE
alternates with
To continue press
.
The print cartridge is nearing the end of its
useful life and the REPLACE SUPPLIES
setting in SYSTEM SETUP is set to STOP AT
LOW. To override, press
.
1. Order the print cartridge.
2.
Press
to continue.
or
Press
for help.
See
Supplies and accessories on page 187
for more information.
REPLACE SUPPLIES
alternates with
For status press
At least two print cartridges are out and need
to be replaced.
1.
Press
to identify which supplies
should be replaced.
2.
Press
for help.
See
Replace supplies and parts
on page 125 for more information.
See
Supplies and accessories on page 187
for more information.
REPLACE SUPPLIES
alternates with
To continue press
More than one supply item is low, and the
REPLACE SUPPLIES setting in SYSTEM
SETUP is set to STOP AT LOW.
1. Press Menu and navigate to the
SUPPLIES STATUS menu in order to
identify which supplies should be
ordered.
2. Order the supplies.
3.
Press
to continue printing.
See
Supplies and accessories on page 187
for more information.
REPLACE SUPPLIES
Override in use
alternates with
Ready
At least one print cartridge is out, but printing
is continuing. Print-quality problems might
occur.
1.
Press
to identify which supplies
should be ordered.
2. Order the identified supplies.
See
Supplies and accessories on page 187
for more information.
REPLACE SUPPLIES
Using black only
alternates with
Ready
At least one color print cartridge is out.
Printing can continue, but only the black
cartridge is being used.
1.
Press
to identify which supplies
should be ordered.
2. Order the identified supplies.
See
Supplies and accessories on page 187
for more information.
Request accepted please wait The printer has accepted a request to print an
internal page, but the current job must finish
printing before the internal page will print.
No action necessary.
Resend upgrade The firmware upgrade was not successful. Attempt the upgrade again.
Restoring factory settings The printer is restoring factory settings. No action necessary.
Restoring... The printer is restoring settings. No action necessary.
RESTRICTED FROM PRINTING IN COLOR
alternates with
The message appears when the printer is set
to COLOR IF ALLOWED and you or your
software program are not authorized to print
in color.
Get your network administrator to set the user
or program permissions that will allow you to
print in color.
ENWW Control-panel messages 149
To Next Page
Loading...
