6. Slide the paper width guides inward until they lightly touch the print media stack on both sides
without bending it. Make sure that the media fits under the tabs on the width guides.
CAUTION: Wait for the printer to finish printing before closing tray 1 (optional). Closing
the tray before the printer finishes can cause jams.
Load envelopes in tray 1
Many types of envelopes can be printed from tray 1. Up to 10 envelopes can be stacked in the tray.
Printing performance depends on the construction of the envelope.
In the software, set margins at least 15 mm (0.6 in) from the edge of the envelope.
NOTE: Testing has shown that fusing performance is improved when the Extra Heavy fuser
mode is used when printing on C5 and B5 envelopes. To change this setting, press Menu. Then
press
to highlight CONFIGURE DEVICE, and then press . Press to highlight PRINT
QUALITY, and then press
. Press to highlight PRINT MODES, and then press . Press
to highlight EXTRA HEAVY, and then press .
CAUTION: Envelopes that contain clasps, snaps, windows, coated linings, exposed self-stick
adhesives, or other synthetic materials can severely damage the printer. To avoid jams and
possible printer damage, never try to print on both sides of an envelope. Before you load
envelopes, make sure that they are flat, undamaged, and not stuck together. Do not use
envelopes that contain pressure-sensitive adhesive. To avoid jams, do not remove or insert
envelopes during printing.
1. Open tray 1.
ENWW Load media 67
To Next Page
Loading...
