Figure 5-7 Installation success message
A dialog stating that the installation was successful appears.
Click Close to exit the installer.
Printer setup
After installing the printing-system software in Macintosh operating systems, the printer must be set up.
Topics:
●
Set up a printer with Mac OS X v10.4.3 and above
●
Set up a printer with Mac OS X v10.3.9
●
Troubleshooting the printer setup
Set up a printer with Mac OS X v10.4.3 and above
Carry out these steps after the software installation is complete.
1. If you are installing the printer using a USB connection, connect the USB cable between the HP
LaserJet P1000 or P1500 Series printer and the computer. Turn on the printer. If you are installing
using a network connection, verify that the network cable is connected to the printer and the printer
is on and proceed to step 4.
114 Chapter 5 Macintosh software and utilities ENWW
To Next Page
Loading...