5. Close the DIMM door.
6. Reconnect all printer cables and cords, and then use the power switch to turn on the printer.
Test the DIMM installation
To test the DIMM installation, print a configuration page, and check the Total Memory specified on the
page. See
Printer information pages for more information.
If all lights on the control panel are blinking, the DIMM installation was unsuccessful. Remove the DIMM
and reinstall it.
Remove a DIMM
To remove a DIMM, follow the instructions below:
CAUTION Handling a DIMM (memory) without wearing a grounded, antistatic device might
damage the DIMM. Touch any metal part of the printer or other grounded metal before touching
the DIMM.
1. Use the power switch to turn off the printer, and then unplug all of the cables and cords connected
to the printer.
ENWW DIMMs (memory or font) 117
To Next Page
Loading...
