Item Sub-item Values Description
MANUAL SENSOR
TEST 2
Performs additional tests to
determine whether the paper path
sensors are operating correctly.
COMPONENT TEST A list of available components
appears.
Activate individual parts
independently to isolate noise,
leaking, and other hardware
issues.
PRINT/STOP TEST Range is 0 - 60,000 milliseconds.
The default is 0.
Isolates print quality faults more
accurately by stopping the product
in mid-print cycle, which allows you
to see where the image begins to
degrade. This causes a jam
message that might need to be
manually cleared. A service
representative should perform this
test.
PRINT FUSER TEST
PAGE
Print this page to determine the
current status of the fuser.
SIGNATURE CHECK CANCEL IF BAD*
PROMPT IF BAD
Configure how the product
responds during a firmware
upgrade if the firmware-upgrade
code does not match the product
signature.
Service menu
The SERVICE menu is locked and requires a PIN for access. This menu is intended for use by authorized
service personnel.
ENWW Service menu 39
To Next Page
Loading...