16
Chapter 1 Controls and Indicators
Controls and Indicators
Electrical Controls and Indicators, Cabinet Models (Figure 1)
Switch or
Indicator
Function
Active
Online
Active
Offline
Power Switch Turns printer on and off: 1 = on, 0 = off. This switch is also a
circuit breaker.
Status Indicator On when the printer is online, off when the printer is offline.
Flashes to indicate a fault or warning.
ää
LCD Liquid Crystal Display. Displays printer status messages,
fault messages, and menus which permit user to set various
configurations.
ää
ONLINE Toggles the printer online and offline. Clears the printer after
a fault is corrected and returns the printer to offline state.
ää
FF Prints any data in the buffer then moves paper to top of form
as defined by the currently active form length.
ää
LF Prints any data in the buffer then moves one line feed as
defined by the currently active line spacing. Repeats if held
down.
ää
VIEW Moves the current print position to the tractor area for
viewing. Press again to move paper back to the print
position.
ää
= (UP)
Displays next higher level of a configuration menu. After
VIEW is pressed, moves paper up 1/72 inch.
ä
> (DOWN)
Displays next lower level of a configuration menu. After
VIEW is pressed, moves paper down 1/72 inch.
ä
< (NEXT)
Displays the next option in a configuration menu.
ä
; (PREV)
Displays the previous option in a configuration menu.
ä
CLEAR Clears the printer after a fault is corrected and returns the
printer to the offline state.
ä
SHIFT + L.P.I ADJ Selects new line spacing.
ä
SHIFT + CLEAR Resets PCL-II emulation.
ä
SHIFT + PAGE L ADJ Selects new form length in inches, which is then selected
with PAGE L ADJ key.
ä
SET TOF Sets the location of the first line of print on a page,
independent of form length.
ä
ENTER Enters an option displayed on the LCD into printer non-
volatile memory. Starts and stops printer tests. Must be
unlocked before using. (See below.)
ä
= + >
Locks and unlocks the ENTER key.
ä
To Next Page
Loading...
