HP LASERJET ENTERPRISE 700 M712

To Next Page

To Previous Page

Preboot menu options

If an error occurs while the product is initializing, an error message displays on the control-panel

display. The user can open the Preboot menus. The error menu item will not be seen if an error did not

occur.

CAUTION: The 2 Format Disk option performs a disk initialization for the entire disk. The

operating system, firmware files, and third-party files (among other files) will be completely lost. HP

does not recommend this action without contacting support first.

Open the Preboot menu

1. Turn the product on.

2. Wait for both the Ready and Attention LEDs to illuminate and then dim out. The HP logo will

appear on the control panel display.

3. When the LEDs illuminate again, press the Stop

button on the control panel.

NOTE: The period of time for opening the Preboot menu, while the Ready and Attention LEDs

are illuminated, is around one second. You might need to press the Stop

button repeatedly

while the product is starting up to make you sure you gain access to the Preboot menu.

4. Use the Down arrow button to navigate the Preboot menu options.

5. Press the OK button to select a menu item.

Cold reset using the Preboot menu

1. Open the Preboot menu.

a. Turn the product on.

b. Wait for both the Ready and Attention LEDs at the bottom right side of the control panel to

illuminate and then dim out. The HP logo will appear on the control panel display.

c. When the Ready and Attention LEDs illuminate again, press the Stop

button on the

control panel.

NOTE: The period of time for accessing the preboot menu, while the Ready and

Attention LEDs are illuminated, is around one second. You may need to press the Stop

button repeatedly while the product is starting up to make you sure you gain access to the

Preboot menu.

d. Use the Down arrow button to navigate the preboot menu options.

e. Press the OK button to select a menu item.

2. Select the 3 Administrator item, and then press the OK button.

3. Select the 8 Startup Options item, and then press the OK button.

ENWW

Preboot menu options

HP LASERJET ENTERPRISE 700 M712 - Page 115