Table 2-50 Print modes under the Adjust Paper Types sub menu (continued)
Resistance Mode Set to Up to resolve print-quality issues caused by poor
secondary transfer in low-humidity environments with resistive
or rough surface paper.
Humidity Mode With glossy film, set to High when the product is in a high-
humidity environment and print-quality defects occur on HP
Tough Paper or Opaque film.
With transparencies, set to High when the product is in a
high-humidity environment and print-quality defects occur on
color transparencies on the first page of a print job.
With all other paper types, set to High when the product is in
a high-humidity environment and light density occurs on the
first page of a print job.
Table 2-51 MP modes under the Optimize submenu
Line Detail Normal
Up
Off
Environment Set to Low Temp if the product is operating in a low-
temperature environment and you are having problems with
print quality such as blisters in the printed image.
Restore Optimize Use this item to reset the menu defaults.
ENWW
Use manual print modes
279
To Next Page
Loading...